To Next Page
M
Michael ObrienAug 12, 2025
What to do if Senco Power Tool is jamming?
- LLaura DavisAug 12, 2025
If your Senco Power Tool is jamming, you should clean the tool, lubricate the magazine, or install Parts Kit D.
What to do if Senco Power Tool is jamming?
If your Senco Power Tool is jamming, you should clean the tool, lubricate the magazine, or install Parts Kit D.
How to fix a Senco SLS25 Power Tool with air leak?
To address an air leak near the top of your Senco Power Tool accompanied by sluggish operation, verify the air supply and tighten the screws, or install Parts Kit A.
How to fix weak drive on Senco Power Tool?
To fix a weak drive on your Senco Power Tool due to a broken or worn driver, verify adequate air supply or install Parts Kit C.
General| Type | Stapler |
|---|---|
| Fastener Type | Staples |
| Gauge | 18 |
| Operating Pressure | 70-120 PSI |
| Magazine Capacity | 150 |
| Power Source | Pneumatic |
| Staple Crown | 1/4 inch |
| Tool Type | Pneumatic |
