Sencor SBD 1470 - Page 6

Digital Blood Pressure Monitor with a Wrist Cuff
SBD 1470
DESCRIPTION OF THE DISPLAY
БЕСІГІ
Е 2 а х
МАМРМ D Yr
BAS iS
CIAL
Time/Date
Cuff air release indicator
Flat battery indicator
Display of date and time
Systolic pressure value
Measuring unit
Diastolic pressure value
Pulse rate (number of pulses/minute)
Display of the memory sequence
number
Measured blood pressure category
indicator
Detection of wrist movement during
measurement
Detection of cardiac arrhythmia
ӨӨС
USING THE BLOOD PRESSURE MONITOR
. Installing and replacing batteries
. To power the device use two LR0O3/AAA (2 x 1.5 V) type batteries.
. Remove the battery compartment cover and insert two LRO3/AAA type batteries. When inserting
the batteries ensure the correct polarity as shown in the battery compartment. Close the cover.
° The batteries need to be replaced when:
- the display shows the symbol ГП).
- the display is dim.
- the display does not turn on.
Note:
If the polarity is reversed when the batteries are inserted, the device may not only not function
but may also heat up.
Do not combine used and new batteries or batteries of various types, e.g. alkaline batteries and
rechargeable batteries.
Saved records will remain stored in the device's memory even after the batteries are replaced.
EN-6
Copyright © 2012, Fast ČR, a.s. Revision 11/2012