Sencor SBD 1470 - Page 9

Digital Blood Pressure Monitor with a Wrist Cuff
SBD 1470
4. Recalling memory
41 To show the last measurement record press the MEM А button.
4.2 Toscroll through the individual measurements in memory, use the MEM А and SET У buttons.
43 For each measurement the month/day and the time the measurement was taken will be shown in
the bottom left hand part of the display.
44 The most recent measurement stored in memory always has the sequence number of 1. The
maximum memory capacity is 60 measurements. As soon as the maximum memory capacity is
achieved, every new measurement will delete the oldest measurement.
5. Deleting memory
5.1 Press the MEM А button. The display will show the last stored record. Then hold down the
MEM А button for approx. З seconds. The message "del all" (delete all) will appear on the display.
5.2 Press the SET У button to confirm the deletion of all measurements in memory. The display will
show the message "del" (delete) and "done" (completed). The device will automatically turn
itself off.
Са Note:
If you wish to interrupt the deletion process, press the On/Off button.
53 No values will appear on the display when the memory is subsequently retrieved.
Copyright © 2012, Fast CR, a.s. Revision 11/2012