Sencor SBD 1470 - Page 8

Digital Blood Pressure Monitor with a Wrist Cuff
SBD 1470
° Seat yourself comfortably on a chair and rest your left elbow on a table. The palm faces upwards
(towards the face) and the blood pressure monitor is located level with the heart. Slightly open
the palm and relax the fingers. If the blood pressure monitor is located above or below the level
of the heart the measurement results may not be accurate.
. During measurement sit calmly, relaxed and don't talk. Do not move the hand to which the cuff
is attached.
3.3 Measuring blood pressure
3.3.1 Turn on the device by pressing the On/Off button. In a short time all the elements will light up on
the LCD display.
3.3.2 If residual air remains in the cuff, the symbol Т will appear on the display for a short time and the
air will be released. The value 0 mmHg (or kPa) and the time of measurement will appear on the
display.
3.3.3 The device will automatically pressurise the cuff. While the cuff is being pressurised the pulse rate
is being detected. This is indicated by the flashing y symbol on the LCD display.
3.3.4 Then the pressure in the cuff is continuously released and the values of the systolic (SYS) and
diastolic (DIA) pressure, pulse rate and the blood pressure are automatically determined. The
blood pressure categories are defined in the following table.
Blood pressure category
Measured blood
pressure value in р А G1 G2 G3
mmHg Optimal Normal Normal (high) Mild Medium Heavy
hypertension | hypertension | hypertension
SYS (systolic value) <120 120-129 130-139 140-159 160-179 2180
DIA (diastolic value) <80 80-84 85-89 90-99 100-109 >110
Моќе:
If the symbol D appears on the display, the device has detected cardiac arrhythmia.
3.3.5 Turn off the device by pressing the On/Off button. If you do not turn off the device, it will turn
itself off automatically within 1 minute of the last measurement. Remove the cuff from your
wrist after completing the measurement.
EN-8
Copyright © 2012, Fast CR, a.s. Revision 11/2012