Sencor SBL 5750SS - Page 2

02/2017
- 2 -
Copyright © 2017, Fast ČR, a.s.
EN
Blender
Important safety instructions
READ CAREFULLY AND STORE FOR FUTURE USE.
■ This appliance may be used by persons with physical or mental impairments or by
inexperienced persons, if they are properly supervised or have been informed about how
to use the product in asafe manner and understand the potential dangers.
■ Children must not use this appliance or play with it. Keep this appliance and the power cord
out of reach of children.
■ Before connecting this appliance to apower socket, make sure the voltage stated on its
rating label corresponds to the voltage in your power socket.
■ Only use the appliance with the original accessories that came with it.
■ The appliance is intended and designed for processing astandard amount of food in the
household.
■ Do not use the appliance for any other purposes than those for which it is intended.
Warning:
Improper use can lead to injury.
■ Do not use the appliance in an industrial environment or outdoors.
■ Do not place the appliance on an electric or gas stove or in its vicinity, on the edge of atable
or on an unstable surface. Only place the appliance on an even, dry and stable surface.
■ Make sure that the appliance is correctly assembled before putting it into operation.
■ Pay increased attention when handling hot liquids, because they may release steam or they
could spray and cause burns. Hot liquids or foods need to be allowed to cool down to at
least 45 °C before being placed inside the blending jar.
■ Do not leave the appliance in continuous operation for longer than 2 minutes. Before
turning it on again, allow it to cool down for at least 2 minutes. When processing hard foods
or liquids with avery thick consistency, do not leave the appliance in continuous operation
for longer than 1 minute.
■ The appliance is equipped with athermal fuse protecting the motor from damage in case of
overload. If automatic shut-off of the appliance occurs in consequence of motor overload,
disconnect it from the network socket and let it cool for at least 15 minutes. Then bring the
appliance back into operation.
■ While blending, do not put your hands or items, such as kitchen knives, forks or wooden
spoons into the blending jar. Otherwise, an injury could occur or the appliance could be
damaged.
■ If ingredients stick to the blade assembly or inside walls of the blending jar, switch it off and
unplug it from the power supply. Make sure that the blade assembly has stopped rotating.
Carefully remove the blending jar from the motor unit. Remove the lid and using aplastic
spatula clean the blade assembly and the walls of the blending jar. Put the lid back on and
reattach the blending jar to the motor unit. Plug the power cord into apower socket and
continue blending.