Sencor SBP 901 - Maintenance, Storage, and Calibration; Maintenance and Cleaning; Storage Recommendations; Calibration Advice

Digital Blood Pressure Monitor with Cuff
SBP 901
MAINTENANCE AND CLEANING
° Keep the device clean. Wipe off dust using a lightly damp cloth.
° Do not wash the device or the pressurising cuff under running water or submerge it in water.
° Do not use abrasive cleaning products or petrol for cleaning. Otherwise the device may be
damaged.
STORAGE
° If you will not be using the device for an extended period of time, remove the batteries.
° Protect the device against impacts and falls.
° Store the device in a clean, dry place out of reach of children. Do not expose the device to direct
sunlight or extreme temperature changes.
CALIBRATION
Recommendation: To ensure accurate measurement results we recommend the device is calibrated after
two years of operation. All costs associated with the calibration are borne by the customer.
ELECTROMAGNETIC INTERFERENCE
To prevent measurement inaccuracies caused by electromagnetic interference, do not use this device in
the vicinity of mobile telephones or microwave ovens.
COMPLIANCE WITH STANDARDS
This device complies with European standards:
EN 60601-1 Medical electrical devices - Part 1: General basic safety and necessary functionality
requirements
EN 60601-1 Medical electrical devices - Part 1-2: General basic safety and necessary functionality re-
quirements - Group standard: Electromagnetic compatibility - Requirements and tests
EN 1060-1 Non-invasive blood pressure monitors - Part 1: General requirements
EN 1060-3 Non-invasive blood pressure monitors - Part 3: Specific requirements for electromechanical
systems for the measurement of blood pressure
C Со This device meets the requirements of the European directive 93/42/EEC.
a The manufacturing date is marked on the rating label of the device.
ми Manufacturer: Zhongshan Transtek Electronics Co., Ltd
Jinan Road, Minzhong, Zhongshan, Guandong, China
Authorised representative for the EU: MDSS - Medical Device Safety Service GmbH,
[ec [REP Schiffgraben 4130175, Hannover, Germany
EN-12
Copyright © 2011, Fast ČR, a.s. Revision 03/2011