Sencor SBS 6015BK - Measuring Body Weight; Measuring Body Composition; Setting User Parameters; Manual User Weighing

Personal Fitness Scale
SBS 6015BK / SBS 6015WH
MEASURING BODY WEIGHT
This scale has an "Auto-on" function. It is not necessary to tap with the foot or to otherwise activate
into the operational mode before weighing. If you wish to find out your weight, simply step on the
scale, which will immediately display your current weight without the need to wait.
For standard weighing (i.e. for measuring body weight) it is not necessary to make any further settings.
1) Step on the scale. The scale will turn itself on automatically and start weighing.
2) Stand calmly, within a few seconds the weight value will settle at the final weight.
Note:
The final weight is indicated when the weight unit (kg or st/Ib) is displayed.
MEASURING FAT, WATER, MUSCLE CONTENT AND WEIGHT OF BONES IN THE
BODY
Setting parameters of individual users
We recommend that you first set the parameters for a given user:
1) While the scale is off, press the "SET" button (the user number P1-P8) will start flashing.
2) Using the arrows A and Y select one of the memory positions, where you wish to store your
parameters.
3) Press the "SET" button again (the gender setting icon will start flashing).
4) Using the arrows A and Y select one of the options (order when the arrows are pressed Y):
. male
e female - athlete
e male - athlete
e female
5) Press the "SET" button again (the body height value will start flashing).
6) Using arrows A and Y enter your body height.
7) Press the "SET" button again (the age setting value will start flashing).
8) Using arrows A and Y enter your age.
9) Press the "SET" button to save all the selected parameters in the selected memory position.
After the values have been saved the scale will automatically switch to the weighing mode after
3 seconds and if nobody steps on it within approximately the following 10 seconds it will automatically
turn itself off.
Attention:
e |f while setting your parameters you do not press any button for 20 seconds, the scale will
automatically switch to the stand-by mode and no value will be saved.
e If after pressing the "SET" button you do not continue in setting the first required parameter,
i.e. the user number (memory position) within 5 seconds, the scale will automatically switch
to the stand-by mode and will not save any parameters.
Weighing using manual user identification
1) Turn the scale on by pressing the "SET" button.
2) Using arrows A and Y select your user number (number of your memory position).
3) Wait until a zero weight appears on the display.
4) Now step on the scale with your bare feet.
5) Stand calmly, within a few seconds the weight value will settle at the final weight.
Copyright O 2012, Fast CR, a.s. Revision 10/2012