Sencor Scooter Two Long Range 2021 - Assembling the SCOOTER TWO LONG RANGE 2021

Copyright © 2020, Fast ČR, a. s.
Revision 08/2020
6 EN
Assembling the scooter two long range 2021
EN
3. Assembling the SCOOTER TWO LONG RANGE 2021
1. Unfold the handlebar rod and secure it fi rmly with the lock lever.
2. Make sure that the control unit connectors are connected to the control panel.
The connector with the cords must be connected properly to avoid loosing later on.
3. Carefully connect the handlebar with the handlebar tube. Take care to avoid
damage to the connecting wire while it’s being inserted into the steering tube.
The LED fl ashlight must point in the ride direction.
4. Screw the handlebar and the handlebar tube together. Insert two hex screws
from the front and two hex screws from the opposite side as shown. Tighten
the screws fi rmly. Regularly check if the screws don’t get loose while using the
product.