Sencor SCP 1504BK - Page 4

- 4 -
08/2019
Copyright © 2019, Fast ČR, a.s.
■ The temperature of accessible surfaces on
the appliance is high when the appliance is in
operation and, due to residual heat, for acertain
time after operation. Do not touch the hot
surface of the appliance. There is adanger of
burns.
■ When the appliance is in operation, the
temperature of adjacent surfaces may be higher.
■ Do not use the appliance without apot or pan
placed on the hotplate. Regularly check the
condition of the food while the hotplate is
running.
■ Only use pots and pans intended for cooking.
■ Always make sure that the pot or pan is correctly
placed on the hotplate. The handle of the
cookware must be in asafe position so as to
prevent brushing against it and overturning the
cookware.
■ Be very careful when cooking with oil or
shortening. Shortening or oil heated to ahigh
temperature may ignite.
■ When handling hot cookware, which contains
hot food or liquids, be especially careful so as
not to burn or scald yourself.
■ When handling hot cookware, use kitchen
gloves.
■ The appliance must not be left without
supervision when in operation or when
connected to apower socket.
■ Always check that the temperature control knob
is set to position MIN before connecting the
appliance to apower socket. Always after finishing
using the appliance, set the temperature control
knob to position MIN and disconnect the power
cord from the power socket. Keep in mind that the
hotplate will emit residual heat for acertain time
after it is used. Be especially careful not to touch
the hot surface of the appliance.
Warning:
In the event that the surface of the
hotplate is cracked, immediately turn
the appliance off and disconnect it from
the power socket to prevent possible
injury by electrical shock. Never use the
appliance with acracked hotplate or if it
is damaged in any other way. Hand the
appliance over to an authorised service
centre for repair.
■ Always set the temperature control knob to
position MIN and disconnect the power cord from
the power socket when leaving the appliance
without supervision, when not using it and
before cleaning, maintenance, moving or storing
it. Never move the appliance during operation.
■ Allow the appliance to fully cool down before
moving, cleaning, maintenance or storing it.
Never move the appliance when there is apot or
pan on it or unless it has cooled down completely.
■ Regularly clean the appliance after each use
according to the instructions in the chapter
Cleaning and maintenance. Do not perform
any maintenance on the appliance except for
cleaning as described in this user’smanual.
■ To prevent the risk of injury by electrical shock,
do not submerge the appliance, power cord or
power plug into water or another liquid.
■ Do not place heavy items on the power cord.
Make sure the power cord does not hang over
the edge of atable, that it is not touching ahot
surface or sharp objects.