Sencor SSI 2027BL - Using the Steam Iron; Preparation before Ironing; Ironing with Steam

EN-8
EN
Steam iron
SSI 2027BL / SSI 2028YL
06/2019
Copyright © 2019, Fast ČR, a.s.
USING THE STEAM IRON
• Wipe the ironing surface with a lightly damp cloth before first use and then wipe dry.
PREPARATION BEFORE IRONING
• Sort the laundry according to international symbols shown on the labels or according to the fabric
types.
SYMBOL FABRIC TYPE
SETTING THE TEMPERATURE
CONTROL DIAL
Synthetics (nylon, polyamid,
polyester, etc.)
•
Low temperature
Silk – wool
• •
Medium temperature
Cotton
• • •
High temperature
Linen
MAX
Maximum temperature
Fabric, that should not be ironed.
IRONING WITH STEAM
1. Filling the water tank
• Check that the iron is disconnected from the power socket.
• Set the output steam regulator A4 to the position marked by the symbol
.
• Flip open the filling opening cap on the water tank A5.
• Tilt the iron backwards and fill tank A0 with water. Ensure that the water level does not exceed
the maximum water level mark.
• Close shut the filling opening cap on the water tank A5. Place the iron on a stable, even surface in
a vertical position.
Note:
To fill the tank A0 you may use water that has a medium-hard water hardness level (up to
14 °dH / 2.5 mmol/l).
If water in your area is particularly hard, we recommend that you use 1 part of distilled water
and 1 part of tap water.
2. Setting the temperature control dial
• Ensure that the iron is located in a vertical position on an even stable surface.
• Connect the power cord to an el. power socket.