Steam iron
SSI 2027BL / SSI 2028YL
EN
EN-9
06/2019
Copyright © 2019, Fast ČR, a.s.
• Set temperature control dial A9 based on the fabric type you wish to iron. A lit indicator light A8
signals that the ironing surface is heating up. As soon as the ironing surface heats up to the set
temperature, the indicator light A8 will turn off.
Note:
During first use a weak cracking sound caused by the expanding plastic may be heard. This is an
entirely normal event, which will disappear in a short time.
While ironing the indicator light A8 will intermittently turn on and off. This indicates that the
set temperature is being maintained.
First iron the laundry that requires the lowest temperature. This will save you time because the
iron heats up faster than it cools down.
If you are ironing at a high temperature and then set a lower temperature, wait until the iron
cools down.
3. Steam
• Only use the steam function when the temperature control dial A9 is set to a temperature of
• • to MAX. At a temperature of • • use the regulator A4 to set a weaker steam output
. At
a temperature of • • • to MAX use the regulator A4 to set a stronger steam output
.
Note:
If the set temperature is too low, water may drip from the ironing surface.
The iron continuously emits steam only if you hold it in a horizontal position. Stop the release
of steam by standing the iron upright in a vertical position or by turning the output steam
regulator A4 to the position marked by symbol
.
FUNCTION OF THE STEAM IMPULSE
• Press the steam impulse button A3 to generate a strong flow of steam which can even out even
very crumpled up textiles.
• Only use the steam impulse function when the temperature control dial A9 is set to a temperature
of • • • to MAX. If indicator light A8 turns on, wait until it turns off and only then press the steam
impulse button A3. Wait several seconds before pressing the button again.
• The heat impulse function A3 can be used when ironing textiles (e.g. curtains, hanging clothes,
etc.) in the vertical position.
SPRAYING FUNCTION
• The spraying function can be used when the temperature control dial A9is set to any temperature.
Ensure that there is water in the tank A0 and to dampen the textile press the spray button A2.
Note:
Do not use the spraying function on silk and synthetics.
DRY IRONING
• If you want to iron without steam, follow the instructions in chapter Steam ironing, point 2. Setting
the temperature control dial.
• Set regulator A4 to the position marked by the symbol
.
To Next Page
