EasyManua.ls Logo

Sencotel Granita machine - Washing and Sanitizing Components

Default Icon
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SL310006593 Ed.00 - 07-2011 - 15_EN -
2 raise the front part of the bowl to release it;
3 remove the bowl from its seat by pushing and tapping lightly on the rear
part;
7.4. Washing and sanitizing the components
All of the previously disassembled and removed components must be thor-
oughly washed and sanitized.
Use the sanitizing product as directed on the product label.
To carry out this procedure correctly proceed as follows:
1 fi ll a sink with detergent and hot water (50-60°C);
2 wash the disassembled components with the detergent solution;
3 rinse with hot water, making sure no traces of lubricants remain;
4 fi ll another sink with a sanitizing solution prepared in water ;
5 soak the disassembled components in the sanitizing solution (use the sanitiz-
ing product as directed on the package label);
6 rinse with clean water;
7 place the components on a clean surface and dry them.
Using a damp cloth, clean all product residues from the evaporator.
4 take out the auger and remove the seals (A and B) and side covers.
Fig.29
Fig.30
Fig.31
Fig.32
Wash and sanitize the bowl support and resting surface.
Fig.33
W
Parte exterior
Parte inferior
Fig.34
Warning: do not submerge lids equipped with lighting in any
type of liquid. Before starting the cleaning and sanitising opera-
tions of the lid, remove it from the machine as described in the
previous chapter.
To clean the lighted lid correctly, proceed as follows;
1. Using a clean, damp cloth, fi rst wipe clean the bottom part of the lid (in con-
tact with the product);
2. Using a clean, damp cloth, wipe clean the whole outer part;
3. Using a sponge dipped in sanitising solution, sanitise the bottom part of the
lid, taking care not to wet the contacts (X);
4. Allow to act for 30 minutes;
5. Rinse twice or more, only the bottom part, with a clean sponge soaked in
fresh water.
6. Place the lid on a clean surface and dry it; fi rst dry the bottom and then the
outer part by means of a clean cloth.
7. Set the lid back in place only after having cleaned and sanitised the bowl.

Table of Contents

Related product manuals