Sendum PT300 - Step 2: Charging; Charging Sensor Packs; Charging Accessory Pack Battery

PT300 QuickStart Guide
Part Number BFA10068 (for Verizon)
-- 2 --
Step 2: Charging
Just like with any new mobile device, you’ll
need to charge your device battery before you
can start using it. This is normally an overnight
process, or at least six hours.
• If you are using either the Basic Sensor
Pack or the Advanced Sensor Pack, you can
charge it by connecting it to the AC Adapter
and then plugging the adapter into any
standard electrical receptacle (see “Figure
3 - Charging up a Sensor Pack”).
• If you are using an Accessory Pack with
the 10K mAh Battery Pack, the process is
similar. Just connect the battery to the AC
adapter and then plug the adapter into
the electrical receptacle (see “Figure 4 -
Charging the 10k mAh Battery Pack”)
Device Identifier
PT300 Command
Module
Sensor Pack
AC Adapter
PT USB Cable
Figure 2 - Locating the PT300 Device ID
Figure 3 - Charging up a Sensor Pack
Figure 4 - Charging the 10k mAh Battery Pack