General Security Notes
5
General Security Notes
The ORP Sensor XT1 is an electronic sensor unit for the
measurement of the oxidation-reduction potential (ORP or
short redox-potential) of water and must be used in
combination with SENECT control units.
Since it is an electronic product the common prerequisites
for a safe instrument usage must be fulfilled. The
corresponding control unit must be operatated
with 230 V AC (~50 Hz). Ensure that all cables are
installed safely so that no obstacles for persons are
built and all. Mount all cables and electric devices
protected against direct environmental impacts
like overheating by direct sunlight and water.
Even if the products are protected against spray
water, the product´s lifetime will be elongated, if it is
mounted on a protected place. The ORP Sensor XT1 uses
24 V DC supply voltage which is therefore not of danger for
persons.
For many applications a ground fault circuit interruper
(interrupting current <= 30 mA) is required by law. Inform
yourself about the valid legislation.
To Next Page
Loading...
Need help?
General