Getting started
7
sensor is from -1000 mV up to +1000 mV and the resolution
of the sensor signal is 1 mV. The ORP Sensor XT1 must be
used in combination with SENECT control units. The sensor is
designed for the use in industrial aquaculture applications.
The displayed value refers to the Ag/AgCl-Electrode.
Getting started
Scope of delivery
1 x ORP Sensor XT1 Electronic interface
1 x ORP Sensor XT1 Electrode
1 x ORP Calibration-Solution (+475 mV)
1 x ORP Calibration-BNC-plug (0 mV)
1 x Manual
Note
Please check directly after delivery, that the
package is not destroyed or damaged or was
opened before. Please check also, that all parts as
listed above are included. If anything is missing or broken,
please contact us as soon as possible within 14 days.
Unfortunately, we cannot accept later information of
damage, which happened during the transport.
Installation and start-up
To Next Page
Loading...
Need help?
General