Need help?Do you have a question about the SENKO SI-300 and is the answer not in the manual?
Explains how to interpret readings and status indicators in the normal measurement mode.
Settings related to measurement parameters like decimal point, range, and gas unit display.
Procedures and settings for performing zero and span calibration of the gas sensor.
Configuration options for alarm latching, energized status, and alarm level thresholds.
Lists common error codes displayed by the device and their corresponding causes and solutions.
Guidelines for choosing appropriate installation sites based on safety and gas detection requirements.
General| Detection Range | H2S: 0-100 ppm, CO: 0-500 ppm, O2: 0-30% Vol. |
|---|---|
| Battery Type | Lithium battery |
| Operating Temperature | -20°C to +50°C |
| Target Gas | Carbon Monoxide (CO) |
| Alarm Type | Audible, Visual |
| Detection Gas | Carbon Monoxide (CO) |
| Response Time | <30 seconds |
To Next Page
