Fireplace stove SENKO SP 11
4. INSTALATION
When you unpack the replace stove from its packaging, it must be
inspected in detail in order to detect possible damage caused during
transportation. Observed damage must be reported to the manufacturer
immediately.
At all places on the replace stove where something is connected
(chimney, air supply...) inspection openings must be installed for system
maintenance and servicing.
4.1. SET UP
The replace stove must be placed with a level in a horizontal position
without tilting. It is necessary to ensure minimum distances of the
replace stove from combustible objects: such as wood, chipboard, cork
and materials like that. If the materials are more ammable, such as PVC,
polyurethanes, etc., the safety distances must be doubled.
The minimum distance from fuel surfaces is 800 mm in front and 1000
mm above the stove, and 50 mm in other directions.
It is RECOMMENDED by the manufacturer to place the replace
stove as close as possible to the chimney opening, i.e. to the opening
itself, so that an additional ue pipe does not have to be used.
To Next Page
Loading...
