EasyManua.ls Logo

SENKO SP - Cleaning Procedures; Glass Cleaning

SENKO SP
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Fireplace stove SENKO SP 19
5.3.4. IGNITION IN THE TRANSITIONAL PERIOD
In the transition period, i.e. with higher temperatures outside, a sudden
increase in outside temperature may cause a disturbance in the operation
of the chimney (decrease in negative pressure in the chimney) so that all the
ue gases are not completely drawn into the atmosphere.
Therefore, in the transition period, it is recommended to use smaller
amounts of fuel and smaller pieces of wood to get a livelier re and to
adjust the amount of primary air to improve the ow of ue gases through the
chimney.
6. CLEANING
Cleaning the replace stove should only be done when there is no
re and when the replace stove is cold! The replace stove and chimney
must be cleaned regularly (at least once a month).
6.1. GLASS CLEANING
During normal ignition of the replace stove, especially when the re is
low, deposits of soot and grease can form on the glass. The glass should be
cleaned as needed. Depending on the humidity of the fuel and the
temperature in the combustion chamber, there will be more or less dirt on the
glass, so sometimes it is necessary to clean the glass more often.
It is best to clean the glass when it is cold and gently wipe it with a
dry cloth or absorbent paper.

Related product manuals