Fireplace stove SENKO SP 18
picture 10
5.3.3. ADDING FUEL
In addition to the use of suitable fuel and satisfactory negative pressure in
the chimney, the way in which the replace stove is red has a great
inuence on the cleanliness of the glass on the rebox door.
We recommend only one-layer refueling and, if possible, use logs up to
2/3 of the length of the rebox. There must be a minimum gap of 1-2 cm
between the logs.
Briquettes should be used so that they ll the surface of the combustion
chamber with a minimum distance of 1-2 cm between them.
WARNING! New quantities of fuel should only be placed on the basic
embers, i.e. not on the ame but only on the embers (approx. 1 cm thick).
At least ten seconds before opening the combustion chamber door,
the manual regulator of the primary air must be completely closed in
order to prevent ue gases from leaving the combustion chamber into
the living space. The door must be opened slowly. After adding fuel, close
the door slowly. Open the manual regulator of the primary air so that the
time until the fuel ignites is as short as possible.
After the fuel begins to burn vigorously, adjust the manual regulator
primary air to the desired position according to chapter 5.1.
To Next Page
Loading...
