SENKO SP - Basic Information

Fireplace stove SENKO SP 4
1. BASIC INFORMATION
The SP replace stove is a model from SENKO product range, which can
meet your needs at best. Therefore, we invite you to READ THESE
INSTRUCTIONS CAREFULLY, which will enable you to achieve the best
results.
The replace stove is intended for space heating!
The manufacturer is not responsible for any consequences (injuries
to people, animals or damage to property) resulting from non-compliance
with these instructions. The replace stove is hot in working condition, and
when using it, it is mandatory to use protective heat-insulated gloves.
Children and inrm persons are not allowed to handle the stove. The external
appearance of the replace stove is shown on the front page of this manual.
The basic parts of the replace stove are made from stainless and steel boiler
sheets, and castings from high-quality gray cast iron. When ordering a
replace stove or spare parts, you should specify its full designation:
SP .The replace stove is made in accordance with the EN 15610 standard
and meets all the essential requirements set by the standard.
It is packed on a EURO pallet. During transport, the replace stove must be
secured well enough to prevent tipping over or damaging the stove. The set
comes standard with:
 replace stove SP,
 user manual.
CAUTION! The mass of the replace stove is 70 kg. Therefore, extreme
caution is required when unloading, moving, moving and installing the
replace stove in order to avoid physical injuries.