Why is my Senlan Inverter showing overvoltage?
If your Senlan Inverter is showing an overvoltage error, this could be due to several reasons. First, check the input power supply to ensure it's within the correct range. Second, the deceleration time might be too short; try resetting it to a longer duration. Finally, the braking resistor might be improperly selected; reselect a suitable braking resistor.
What to do if my Senlan SB40S2.2-3.7 is overheating?
If your Senlan Inverter is overheating, there are a few potential causes. The fan might be damaged, in which case you should replace it. Another possibility is that the air vent is blocked; try cleaning it to improve airflow. If neither of these resolves the issue, the failure might be inside the inverter.
What to do if my Senlan SB40S2.2-3.7 has a module fault?
A module fault in your Senlan Inverter can stem from several issues. Begin by checking the input power to ensure it's adequate. If the load is too large, try increasing the inverter capacity. Also, check for any short circuits or grounding issues and eliminate them. If none of these steps resolve the problem, the failure might be inside the inverter.
Why is my Senlan Inverter showing undervoltage?
If your Senlan Inverter displays an undervoltage error, the input voltage might be abnormal; therefore, check the input power. If the input power is normal, the failure might be inside the inverter.
To Next Page
General
