SENLAN SB40 GENERAL
- 5 -
1.5.3 Operation
‧ Switch on the inverter power only after the wiring is completed and
the cover board is attached. Otherwise, electric shock may occur.
‧ Do not touch inverter terminals when electrical power is going to
the inverter even if the motor is stopped. That may lead to electric
shock.
‧ While charging an inverter that has long not been used, it must be
done by gradually increasing the input voltage to the rated value
through a voltage regulator. Otherwise, electric shock or explosion
may occur.
‧ The running inverter can only be stopped by the panel STOP key or
external terminals. Directly cutting off the main power of the running
inverter is prohibited. That may damage the inverter.
‧ Do not touch the braking resistor during the inverter running. That
may lead to electric shock or burn.
Danger
Caution
To Next Page
