Need help?Do you have a question about the Sennheiser e 835 and is the answer not in the manual?
Secure the microphone clamp to a stand and position the microphone.
Connect the XLR-3 socket of the microphone cable to the microphone.
Place the windshield over the microphone head for protection.
Hold the microphone by its body to maintain the pick-up pattern and sound.
Position microphone for optimal sound, considering proximity effect and ambience.
Position monitor speakers to avoid feedback and crosstalk.
Use the on/off switch for operation; lock it with a screw if needed.
Unscrew, clean, and reinsert the sound inlet basket and foam insert carefully.
General| Transducer principle | dynamic |
|---|---|
| Pick-up pattern | cardioid |
| Nominal impedance | 350 ohms |
| Connector | XLR-3 |
| Weight | 330 g |
| Frequency response | 40 - 16000 Hz |
| Minimum terminating impedance | 1000 ohms |
| Dimensions | 48 x 180 mm |
| Sensitivity | 2.7 mV/Pa |
To Next Page
