Sennheiser Evolution EW100 - Operation of Evolution Wireless Series; System Operating Controls Overview

66
6 Operation
Transmitters and receivers of the Sennheiser evolution wireless series ew 100
have been factory-preset to allow immediate use after switch-on ( “5 Pre-
paring the devices for use”). Please note, however, that the transmitter
sensitivity is dependent on the application. To avoid overmodulation and
distortion, please first check whether the preset sensitivity is suitable for
your particular application ( “Adjusting the sensitivity”).
Operating controls
Press the ON/OFF button or the POWER button (EM 100 receiver only) to
switch the transmitters and receivers on or off.
Use the MUTE switch (transmitters only) to noiselessly mute the audio signal
without switching off the transmitter.
Press the SET button
– to select a menu,
– to change to the next menu,
– to return to the top menu level.
Press the UP button
– to adjust the setting of a menu.
Press the DOWN button
– to adjust the setting of a menu.
ON/OFF
POWER
MUTE
SET

