Sennheiser EvolutionWireless EW 300 Series User Manual (English)

Other manuals for Sennheiser EvolutionWireless EW 300 Series

Manual28 pages

Datasheet2 pages

Questions and Answers:

V
Victoria GuerraAug 8, 2025
What to do if RF signal is available but there is no audio signal from Sennheiser Microphone and “MUTE” appears on the display panel?
- M
  Mary PriceAug 9, 2025
  If the display panel shows 'MUTE' but you're getting no audio signal from your Sennheiser Microphone, the transmitter might be muted. To resolve this, cancel the muting. Alternatively, the transmitter may not be sending a pilot tone, so switch the pilot tone transmission on. You can also try switching off the pilot tone evaluation on the receiver. A high squelch threshold on the receiver could also be the cause; try reducing it. Lastly, repositioning the antennas might help.
K
Krista SimpsonAug 13, 2025
How to fix no RF signal issue on Sennheiser Microphone?
- C
  Carol CaseAug 13, 2025
  If your Sennheiser Microphone receiver shows no RF signal, ensure that both the transmitter and receiver are set to the same channel, using the synchronization function if needed. Also, the transmitter might be out of range, so check the squelch threshold setting. Try reducing the distance between the transmitter and receiving antennas, and reposition the antennas. Reducing the squelch threshold may also help.
M
montgomeryrebeccaAug 17, 2025
Why is the audio signal distorted on my Sennheiser Microphone?
- T
  Tim OrtizAug 17, 2025
  If you are getting a distorted audio signal from your Sennheiser Microphone, it could be due to the transmitter sensitivity being set too high. Adjust the transmitter sensitivity correctly. Another cause might be the receiver’s audio output level being too high, so reduce the audio output level.
C
Carlos DuncanAug 21, 2025
What to do if none of the diversity displays appear on Sennheiser Microphone?
- S
  Steven YuAug 21, 2025
  If the diversity displays I or II do not appear on the display panel of your Sennheiser Microphone, the receiver’s squelch threshold might be set too high, so reduce it. Also, the transmitter’s RF signal could be too weak; increase the transmission power and reduce the distance between the transmitter and receiver. Check the antenna cables or the antennas to ensure they are correctly connected.
A
Allison OwensAug 26, 2025
How to reduce background noise in Sennheiser Microphone audio signal?
- K
  Kenneth VegaAug 27, 2025
  If the audio signal from your Sennheiser Microphone has a high level of background noise, the transmitter sensitivity might be adjusted incorrectly. Adjust the transmitter sensitivity to the correct level.
B
Brian RivasAug 30, 2025
Why I have no access to a certain channel on my Sennheiser Microphone?
- T
  tmillerAug 30, 2025
  If you cannot access a certain channel on your Sennheiser Microphone, it could be because an RF signal was detected on this channel during scanning, and the channel was locked. To fix this, set the transmitter operating on this channel to a different channel and redo the frequency preset scan. Alternatively, a transmitter of your system operating on this channel might not have been switched off during scanning; switch the transmitter off and redo the frequency preset scan.
B
Brian HinesSep 3, 2025
What to do if my Sennheiser Microphone has no operation indication?
- B
  Brittany McdonaldSep 3, 2025
  If there is no operation indication on your Sennheiser Microphone, ensure the mains unit is properly connected.