Need help?Do you have a question about the Sennheiser MKH 416 T and is the answer not in the manual?
General| Brand | Sennheiser |
|---|---|
| Model | MKH 416 T |
| Category | Microphone |
| Language | English |
Details the 3-pin standard and Cannon plug types used.
Describes wiring configurations for different standards like DIN 41524 and DIN 45595.
Mentions standard connectors like T 3261001 for cables.
Provides physical dimensions of the microphones.
Lists the weight of the MKH 416 T and MKH 416 T-U.
Specifies the microphone's frequency range from 40 to 20,000 Hz.
Explains the microphone uses a pressure gradient-line transducer.
Describes the super-cardioid lobe pattern at low/medium frequencies.
States the microphone's sensitivity as 20 mV/Pa ± 1 dB.
Details the impedance, approx. 2 Ω balanced, earth free.
Specifies the minimum load impedance as ≥ 400 Ω.
Provides the signal-to-noise ratio as approx. 73 dB.
Indicates the maximum sound pressure level is 30 Pa (124 dB).
Specifies the required operating voltage as 12 V ± 2 V.
States the microphone's current consumption as approx. 6 mA.
Defines the operating temperature limits from -10° C to +70° C.
Explains the low impedance output of the RF condenser microphone capsule.
Details A-B powering, voltage matching, and cable screening for noise immunity.
Describes connecting via a battery adapter or power supply.
Explains earthing one side of the balanced output for unbalanced inputs.
Advises using a voltage divider for amplifiers with very high input sensitivity.
Recommends series resistors for input impedances less than 400 Ω.
Details powering directly from an amplifier with 12V supply and feed resistors.
Foam-rubber windshield for reducing wind disturbances.
Clamp for fitting microphones on tripods and booms.
Swivel mount for use with desk stands and microphone clamps.
Shock mount to prevent disturbance from mechanical vibrations.
Desk stand component for the MKH 416 T.
Details battery adapters MZA 15 and MZA 15-U for continuous operation.
Unit for simultaneous powering of two microphones from mains supply.
Triple conductor screened cables with 3-pin connectors.
Cable for connecting series 6 microphones to 'Mikroport' transmitters.
Cable for microphones with suffix U, fitted with a cannon female connector.
Amplifier for connecting condenser or dynamic mics to Nagra units.
Filter to be included between supply voltage source and amplifier input.
Battery adapter for microphones, details article number.
Battery adapter for MKH-U types, details article number.
Power supply unit, details article numbers.
Amplifier for microphones, details article number.
Filter unit, details article number.
Connecting cable, details article number.
Connecting cables, details article numbers.
Connecting cable, details article number.
To Next Page