Need help?Do you have a question about the Sennheiser MKH 50 and is the answer not in the manual?
General| Type | Condenser |
|---|---|
| Polar Pattern | Super-cardioid |
| Sensitivity | 25 mV/Pa |
| Impedance | 150 Ohms |
| Maximum Sound Pressure Level | 134 dB |
| Power Supply | 48 V phantom power |
| Min. Terminating Impedance | 1000 Ohms |
| Equivalent Noise Level CCIR-weighted | 21 dB |
| Current Consumption | 2 mA |
| Connector | XLR-3 |
| Diameter | 25 mm |
| Length | 153 mm |
| Signal-to-Noise Ratio | 82 dB |
| Frequency Response | 40 Hz - 20 kHz |
| Equivalent Noise Level | 12 dB(A) |
| Acoustical Operating Principle | Pressure gradient |
Specifies phantom power requirements and connector details for the microphone.
Explains the use of the 10 dB pad switch to reduce microphone sensitivity.
Details the switchable filter for proximity effect and low-frequency noise.
Power supply for 48 V phantom supply, allowing simultaneous supply of two microphones.
Adapter for independent power supply using a 9V battery converted to 48V.
Three-conductor, shielded cable, 7.5 m long, for connections.
Features high damping of structure-borne noise.
Enables microphone adjustment in any direction.
For mechanical connection when used for MS-stereo recordings.
To Next Page