Why is there no audio signal in my Sennheiser Momentum Wireless M2 AEBT?
If your Sennheiser Headphones produce no audio, here's what to check: * First, ensure your headphones are properly paired with your device. If not, pair them again. * Increase the volume, as it might be set too low. * Make sure that your headphones are switched on.
How to fix Sennheiser Momentum Wireless M2 AEBT Headphone that cannot be switched on?
If your Sennheiser Headphone won't turn on, it might be due to the following reasons: * The battery is empty. In this case, charge the headphones. * The battery is completely exhausted or worn out. If this is the case, visit an authorized Sennheiser service center for battery replacement.
General| Type | Over-ear |
|---|---|
| Connectivity | Bluetooth, Wired |
| Driver Type | Dynamic |
| Frequency Response | 16 Hz - 22 kHz |
| THD | < 0.5% |
| Bluetooth Version | 4.0 |
| Bluetooth Profiles | A2DP, AVRCP, HSP, HFP |
| NFC | Yes |
| Microphone | Yes |
| Charging Time | 3 hours |
| Cable Length | 1.4 m |
| Connector | 3.5 mm |
| Foldable | Yes |
| Carrying Case | Yes |
| Impedance | 28 Ohms |
| Codecs | aptX, SBC |
| Battery Life | 22 hours |
| Noise Cancellation | Active Noise Cancellation |
| Sound Pressure Level (SPL) | 113 dB (1 kHz, 0.5 Vrms) |
Guidelines to prevent hearing damage, protect from magnets, and keep away from children.
Instructions on keeping the product dry, avoiding extreme temperatures, and using approved accessories.
Highlights features like Bluetooth, NoiseGard, NFC, and long battery life.
Explains the functions of the power button and the 3-way multi-function button.
Instructions on how to charge the headphones and battery status indicators.
Step-by-step instructions for pairing using NFC technology.
Step-by-step instructions for pairing via Bluetooth search.
Instructions on how to switch the headphones on and off using the power button.
How to accept, reject, end, and manage incoming calls.
Solutions for issues like headphones not switching on or no audio signal.
Troubleshooting steps for connection failures and pairing errors.
To Next Page