To Next PageTo Next PageWhy my Sennheiser Headphones cannot be switched on?
If your Sennheiser Headphones won't turn on, it's likely due to one of these reasons: * The battery is empty, so you should charge the headphones. * The battery is completely exhausted or worn out. In this case, you should visit an authorized Sennheiser service center for a battery replacement.
How to fix Sennheiser PXC 550 Bluetooth/NFC connection issues?
If your Sennheiser Headphones and smartphone aren't connecting via Bluetooth or NFC, consider these possibilities: 1. Ensure the headphones are powered on during pairing. 2. If your smartphone doesn't support NFC pairing, manually pair the headphones using Bluetooth. 3. If the headphones are in flight mode, activate Bluetooth. Also, unplug any audio cable from the audio input. 4. Make sure that Bluetooth is activated on the headphones.
Why Sennheiser Headphones do not enter pairing mode after pressing the Effect Mode Control button?
If your Sennheiser Headphones aren't entering pairing mode after pressing the Effect Mode Control button for 4 seconds, here's what might be happening: * Bluetooth might be deactivated on the headphones, so ensure it's turned on. * Music might be playing through the headphones, or a call might be in progress. Restart the headphones by turning them off and on again, as they can't enter pairing mode during music playback or calls.
How to fix Sennheiser Headphone that cannot be switched on?
If your Sennheiser Headphones aren't turning on, the most likely reason is that the battery is empty. Try charging them. If charging doesn't help, and you suspect the battery is completely exhausted or worn out, you should visit an authorized Sennheiser service center to get the battery replaced.
What to do if there is no audio signal from my Sennheiser Headphones?
If you're not getting any sound from your Sennheiser Headphones, here are a few things to check: * Make sure your headphones are properly paired with your smartphone. If they aren't, try pairing them again. * Increase the volume, as it might be set too low. * Ensure that the headphones and smartphone are successfully paired, and that the headphones are not stuck in pairing mode.
Why Sennheiser Headphones do not automatically go to pairing mode?
If your Sennheiser Headphones aren't automatically going into pairing mode, the most likely reason is that Bluetooth is deactivated on the headphones. Make sure to activate Bluetooth.
What to do if there is no audio signal in Sennheiser PXC 550 Headphone?
If you're not getting any sound from your Sennheiser Headphones, there might be a few reasons. First, check if the headphones are properly paired with your device; if not, pair them again. Also, make sure the volume isn't too low and that your headphones are switched on.
What to do if Sennheiser Headphones do not respond to button presses?
If your Sennheiser Headphones aren't responding when you press any buttons, it could be due to a malfunction. Try restarting them by switching them off and on again. If that doesn't work, perform a reset.
Why can't I hear voice prompts on my Sennheiser Headphones?
If you can't hear the voice prompts specified in the instruction manual for your Sennheiser Headphones, it might be because Voice Prompt is deactivated in CapTune. Activate Voice Prompt in CapTune to resolve this.
Why does audio stop when adjusting Sennheiser Headphones?
If the audio stops when you adjust your Sennheiser Headphones, it's likely because Smart Pause is active. Adjusting or taking off the headphones triggers a pause command. Make sure that the headphones fit comfortably around the ears with gentle pressure. If needed, deactivate Smart Pause in CapTune.
General| Impedance | 490 Ω |
|---|---|
| Driver type | Dynamic |
| Ear coupling | Circumaural |
| Headphone frequency | 17 - 23000 Hz |
| Headphone sensitivity | 110 dB |
| Total Harmonic Distortion (THD) | 0.5 % |
| Battery recharge time | 3 h |
| Bluetooth | Yes |
| Bluetooth version | 4.2 |
| Connectivity technology | Wired & Wireless |
| Headset type | Binaural |
| Product type | Headset |
| Product color | Black, Grey |
| Wearing style | Head-band |
| Recommended usage | Music |
| Microphone type | Not available |
Weight and Dimensions| Weight | 227 g |
|---|
