Sennheiser RS 2000 - Charging the Stethoset Receivers Rechargeable Battery

Putting the RS 2000 into operation
14 | RS 2000
Charging the stethoset receiver’s rechargeable
battery
A complete charging cycle takes about 3 hours. Before using the
receiver for the first time, charge its rechargeable battery for a com-
plete charging cycle without interruption.
When the rechargeable battery is almost empty, the
Receiver status
LED lights up red. The stethoset receiver switches off after a few
minutes.
왘 Place the stethoset receiver into the transmitter’s charging com-
partment so that the volume buttons face upwards. The ste-
thoset receiver is magnetically oriented to the correct position.
The stethoset receiver automatically switches off and the
Bat-
tery
LED on the transmitter lights up red. When the recharge-
able battery is fully charged, the
Battery LED goes off.
If the
Battery LED on the transmitter flashes red, a charging
error/battery error has occurred. In this case, remove the stethoset
receiver from the transmitter’s charging compartment. More infor-
mation on the rechargeable battery can be found on page 20.
3 h
100 %
Always store the stethoset receiver in the transmitter’s
charging compartment to ensure that it is fully charged when
needed. The intelligent battery charging technology prevents
overcharging.
3 h
100 %
O