Senor Tech SHOP POS - User Manual

Questions and Answers

J
Jennifer RogersSep 12, 2025
Why do Senor Tech Touch terminals show 'Invalid configuration information' message?
- A
  Alex PattersonSep 12, 2025
  If your Senor Tech Touch terminals display an 'Invalid configuration information' message or show incorrect memory amounts, run the CMOS Setup utility. Ensure the amount of base memory defined by the setup utility is correct and matches the actual system memory. If the problem persists, turn off the Upper Part, unplug the power cord, and reseat the SIMM RAM modules on the motherboard. If the issue continues, remove each SIMM and inspect for damage, as a SIMM may be defective.
J
josephnelsonSep 12, 2025
What causes unrecoverable disk error on Senor Tech Touch terminals?
- W
  William ReidSep 13, 2025
  If an unrecoverable disk error occurs after prolonged use of your Senor Tech Touch terminals, turn off the Upper part and allow it to cool down for a few minutes. Check that the removable hard disk drive is firmly seated in the drive bay and that nothing is obstructing airflow into the Upper part or Power Supply, such as cloth or paper.
S
Shane WagnerSep 15, 2025
Why do Senor Tech SHOP POS beep four or seven times?
- A
  Ashley CooperSep 15, 2025
  If your Senor Tech Touch terminals beep four or seven times and the LCD doesn't work, follow the same steps as for continuous beeping: For wireless I/R keyboard, move keyboard away from Upper Part, if problem is fixed, check for stuck keys or low batteries in the keyboard. For wired keyboard unplug the keyboard, if problem is fixed check for stuck keys on the keyboard. If problem was not fixed, turn off the Upper Part, unplug the power cord and remove the covers to gain access to the motherboard's SIMM RAM modules. Carefully reseat the modules.