Getting Started
Connections - single/multiple output, no breakers
Need Help?
REFER TO THE USER MANUAL OR CONTACT SENS CUSTOMER SERVICE:
800-742-2326 / 303-678-7500 /
service@sens-usa.com
USE YOUR SMART PHONE QR CODE READER TO ACCESS USER MANUAL
PATENTED US 9,270,140; 9,385,556; 9,413,186; 9,509,164; 9,466,995; 9,948,125
Automatic Battery Charger/Power Supply
REMOVE PLUGGABLE
ALARM TERMINAL BLOCK
TO INSTALL ALARM WIRES
SEE INSIDE COVER LABEL
FOR FACTORY ALARM
ASSIGNMENTS
CONNECT RS-485 MODBUS
OR J1939 NETWORK CABLE
TO RJ-45 CONNECTOR
(see user manual for
connector pinout, RJ-45 to
terminal block adapter p/n
208026 available from SENS)
*CONNECT TCP/IP MODBUS
NETWORK CABLE TO RJ-45
CONNECTOR
(optional feature)
CONNECT DC WIRES AT
TERMINAL BLOCKS
(multiple outputs optional)
SEE INSIDE COVER LABEL
FOR FACTORY OUTPUT
CONFIGURATION
REMOTE BATTERY
TEMPERATURE SENSORS
(optional, one per output)
CONNECT AC WIRES
AT TERMINAL BLOCKS
100
-
240VAC, 50/60HZ
SENSbus - CHARGER LOAD
SHARING, REMOTE
ACCESSORIES OR SENS
SETUP UTILITY
(do not connect J1939,
TCP/IP or RS-485 here)
*See user manual for details regarding J1939 and TCP/IP Modbus configuration
CONNECT
GROUND WIRE
Connections - single output with breakers
MULTIPLE OUTPUTS
OPTIONAL
(outputs share common
negative connection)
REMOTE BATTERY
TEMPERATURE SENSOR
(connect at leftmost
terminal block)
DO NOT CONNECT AT
TERMINAL BLOCK WHEN
BREAKER PRESENT
DO NOT CONNECT AT
TERMINAL BLOCK WHEN
BREAKER PRESENT
REMOVE PLUGGABLE
ALARM TERMINAL BLOCK
TO INSTALL ALARM WIRES
SEE INSIDE COVER LABEL
FOR FACTORY ALARM
ASSIGNMENTS
CONNECT RS-485 MODBUS
OR J1939 NETWORK CABLE
TO RJ-45 CONNECTOR
(see user manual for
connector pinout, RJ-45 to
terminal block adapter p/n
208026 available from SENS)
*CONNECT TCP/IP MODBUS
NETWORK CABLE TO RJ-45
CONNECTOR
(optional feature)
CONNECT DC WIRES AT
BREAKER TERMINALS
SEE INSIDE COVER LABEL
FOR FACTORY OUTPUT
CONFIGURATION
CONNECT AC WIRES AT
BREAKER TERMINALS
100
-
240VAC, 50/60HZ
SENSbus - CHARGER LOAD
SHARING, REMOTE
ACCESSORIES OR SENS
SETUP UTILITY
(do not connect J1939, TCP/IP
or RS-485 here)
CONNECT
GROUND WIRE
CONNECT SENS SETUP
UTILITY TO USB WHEN
OPTIONAL TCP/IP
MODBUS PCA INCLUDED
CONNECT SENS SETUP
UTILITY TO USB WHEN
OPTIONAL TCP/IP
MODBUS PCA INCLUDED
To Next Page
Need help?
General
