Sentec SDM - Sensor Removal; Procedure for Sensor Removal and Docking

Sentec AG, Ringstrasse 39, CH-4106 Therwil, Switzerland, www.sentec.com
HB-010103-e Date of release: 01/2022
7
2.3 Connecting the Isolation Transformer
Important notes:
• The Isolation Transformer (RFT100VA-V1 and RFT100VA-V2) is intended for use only with the
Sentec Digital Monitor (SDM). Any modification to the Isolation Transformer, to the SDM or to the
installation procedure as described in this manual, may result in physical injury, inaccurate
measurements, and/or damage to the device.
• Do not use the Isolation Transformer if the housing or cables are damaged.
• Do not throw or drop the Isolation Transformer. This may damage the inside of the unit.
• Never connect the SDM mains cable to multiple socket outlets or extension cords.
The Isolation Transformer is only to be used below 2000 m a.s.l. (<80 kPa).
1
Place Isolation Transformer horizontally on the
floor.
Make sure the SDM mains cable is disconnected
from mains and from the SDM.
Connect the SDM mains cable (C13) to the isolation
transformer (C14).
2
Use the Water Protection Box (or similar product)
to secure the cable connection and place it on a flat
surface on the floor.
Note: Do not immerse Water Protection Box in
water.
3
Connect the transformer (C13 plug) to the SDM
(C14 socket).
C14
C13