Rev B Doc. 6001036 Page 11 of 20
PROGRAMMING WITH THE USE OF A TERMINAL\MODEM
The following examples are for those programming the Horizon by terminal/modem. The AREA 06
menu will provide you with four (4) selections. These selections are as follows:
1. WELCOMING MESSAGE
2. DIRECTIONS PAGE
3. AFTER DIALING PAGE
4. ALL OTHER MESSAGES
To begin programming the screen messages, enter the number associated with the area you wish
above. The following pages will give you directions for programming each area above, as well as a list
of the default messages in each area. IMPORTANT NOTE: Only the welcoming message needs to be
programmed. The other choices do not need to be changed. In fact, we strongly recommend that you
leave the others unchanged, unless your particular application requires that they be changed.
1. WELCOMING MESSAGE
This message is shown on the screen when the unit is not being used by a visitor. It should greet the visitor,
tell him/her where they are, and what to do next. IMPORTANT NOTE: The factory setting for this area is a
generic message stating "WELCOMING MESSAGE". Therefore, this area must be programmed.
SYSTEM PROMPT
EXAMPLE OF
TYPICAL ENTRY
IMPORTANT NOTES
WHICH LINE NUMBER WOULD YOU LIKE
TO CHANGE (1-2)? __
1 + ENTER INDICATES THAT YOU WISH TO
ENTER INFORMATION FOR LINE 1.
ENTER 16 CHARACTERS OR LESS FOR
THIS LINE ___________________
WELCOME TO
+ ENTER
TO ENTER A LINE, PRESS A SPACE
AND THE "ENTER" BUTTON.
2. DIRECTIONS PAGE
This message provides instructions for system use. It includes 3 screens of 2 lines with 16 characters. Each
line has a factory default instruction line (shown below) that should not be changed. If you decide to change
the instructions and then later decide to change them back to the factory settings, simply enter a zero (0). The
message will be displayed on the terminal's screen as shown below.
SYSTEM PROMPT
EXAMPLE OF
TYPICAL ENTRY
IMPORTANT NOTES
THESE MESSAGES ARE THE DIRECTORY
INSTRUCTIONS
1 + ENTER --ENABLES EDITING OF LINE 1.
--UNLESS YOUR APPLICATION
{TOP} {BOTTOM}
LINE 1: HOLD # KEY IN TO SEE DIRECTORY
LINE 2: # TO GO FORWARD
✱
TO GO BACKWARD
LINE 3: OR ENTER CODE ON KEYPAD TO DIAL
ENTER LINE NUMBER (1-3) TO CHANGE, ESC TO EXIT, OR 0
TO RETURN ALL LINES TO DEFAULT __
REQUIRES YOU TO CHANGE
THESE MESSAGES, IT IS
STRONGLY ADVISED THAT YOU DO
NOT CHANGE ANY OF THE
MESSAGES IN THIS SECTION.
To Next Page
Loading...