Page 12 of 20 Doc. 6001036 Rev B
3. AFTER DIALING PAGE
This message provides the user with instructions about what to do while the system is dialing and after the
conversation. If after programming your own instructions, you decide that you want to go back to the factory
default for this area, simply enter a zero (0).
SYSTEM PROMPT
EXAMPLE OF
TYPICAL ENTRY
IMPORTANT NOTES
THIS IS THE AFTER DIALING PAGE: 1 + ENTER --ENABLES EDITING OF LINE 1.
--UNLESS YOUR APPLICATION
{TOP} {BOTTOM}
LINE 1: PRESS
✱
IF BUSY OR NO ANSWER
REQUIRES YOU TO CHANGE
THESE MESSAGES, IT IS
STRONGLY ADVISED THAT YOU DO
NOT CHANGE ANY OF THESE
MESSAGES IN THIS SECTION.
4. ALL OTHER MESSAGES
These messages are used to prompt and direct the user through various steps of the system. If after
programming your own messages you decide to return to the factory default messages, simply enter a
zero (0).
SYSTEM PROMPT
EXAMPLE OF
TYPICAL ENTRY
IMPORTANT NOTES
THESE ARE ALL THE OTHER MESSAGES: 1 + ENTER --ENABLES EDITING OF LINE 1.
--UNLESS YOUR APPLICATION
{TOP} {BOTTOM}
LINE 01: ACCESS GRANTED PLEASE ENTER NOW
LINE 02: SYSTEM IS DIALING
LINE 03: LINE NOW FREE PRESS # TO DIAL
LINE 04: LINE IS IN USE
LINE 05: LINE IS STILL BUSY
LINE 06: THANKS FOR USING SENTEX SYSTEMS
LINE 07: PLEASE TRY AGAIN LATER
LINE 08: INVALID ENTRY
LINE 09: NOW TRY AGAIN
LINE 10: SYSTEM IN USE
LINE 11: INVALID CODE
LINE 12: CODE:
ENTER LINE NUMBER (01-12) TO CHANGE, ESC TO EXIT, 00
TO RETURN ALL LINES TO DEFAULT __
REQUIRED YOU TO CHANGE
THESE MESSAGES, IT IS
STRONGLY ADVISED THAT YOU DO
NOT CHANGE ANY OF THESE
MESSAGES IN THIS SECTION.
To Next Page
Loading...