Sentinel KalGuard - TYPICAL INSTALLATION

Page 5 KalGUARD
®
Installation Manual V3 04/18
Installation Advice
TYPICAL INSTALLATION
When installed, the KalGUARD ‘kit’ will have this general appearance.
By-pass Valve
Side-stream
Isolation Valves
Drain Valve
Anode Unit
Controller
Flow Meter
Filter 55µM
Drain Valves
Non-return
Valve
Fig. 2
Filter
Controller
Anode UnitWater
Meter
Mains System
Mains 240V/50Hz
(Single phase)
Water Flow Direction
NRV
Drain Drain
Anode Unit
Earth Strapping Clip Anode Unit Supply Cable
Power Cable
Controller
Signal Cable