.................................................................................................................
SPECIFICATION
FUNCTION
1.Display(4.3”Touch screen)----------------Used to show Deck waveforms and vital FX,BPM and Utility inform ation. Users
will have access to a variety of customization menus and parameter adjustments
via the on-board touch screen.
2.Source Selector Switch---------------------This controls input source for each deck. USB-A, PH/CD, CD or USB-B. This
control also determines which track information is shown on the screen. Parts
used should Match RANE feel.
3.Back-------------------------------------------Pressing allows step back to see crate level.
4.Level/Gain-----------------------------------Adjust the input gain from off to +10dB. Unity gain (no boost or cut) is at 12 o’clock
5.Filter------------------------------------------The FIL TER sweeps from Low-Pass to High-Pass.
6.Cue/PFL--------------------------------------Activates PFL for selected channel.
7.Channel Fader-------------------------------Controls the volume for the specific channel. These faders use magnetic non-contact
mechanisms with no noise and no bleed. Each fader has Reverse, Contour contols
on the front panel. Fader cut-in is set using the touch screen.
8.Crossfader------------------------------------These faders use magnetic non-contact mechanisms with no noise and no bleed.
Reverse and Contour controls on the front panel. Fader cut-in is set using the touch
screen.
9.VU Meter/Channel--------------------------Each Deck channel has a mono meter to assist in setting levels.
10.Master---------------------------------------This control adjusts the volume of the Main XLR outputs.
11.Booth----------------------------------------This control adjusts the volume of the Booth 1/4” TRS outputs.
12.Session Out---------------------------------This control adjusts the volume of the Session RCA outputs.
13.Parameter Encoder-------------------------This will control hardware FX parameters.
14.Menu-----------------------------------------This will provide instant access to the on board control panel on the display.
15.Pad Mode Selection------------------------Controls pad mode functions. Five primary, Five secondary, and Five user defined
modes per deck.
16.Performance Pads--------------------------Velocity sensitive, with adjustable. Used for software control and to trigger
Hardware FX.
17.Foot switch input--------------------------Supports 3-switch passive contact closure footswitch
MODEL:SEVENTY-TWO
To Next Page
Need help?
General
