Need help?Do you have a question about the Serpent 720 and is the answer not in the manual?
General| Brand | Serpent |
|---|---|
| Model | 720 |
| Category | Motorized Toy Car |
| Language | English |
Basic adjustments for initial setup of the Serpent 720.
Reference to a separate guide for parts and assembly views.
Information regarding safety precautions for assembly and use.
Explanation of lines and symbols used in assembly instructions.
Information about the Serpent website for updated details.
Filling and re-assembling the shock absorbers.
Filling front and rear gear differentials with specified oil.
Assembling the front suspension arms and related components.
Installation of the front anti-roll bar.
Attaching suspension arms to the main chassis.
Assembly of the front steering blocks.
Adjusting front belt tension using eccentric hubs.
Installation and adjustment of front downstop screws.
Assembling the front upper suspension arms.
Setting the caster angle using spacers.
Final assembly of steering blocks and related parts.
Setting front track-width and camber.
Installing drive belts and associated gears.
Attaching components to the chassis.
Initial assembly of rear suspension components.
Assembling the rear suspension blocks.
Assembling the lower rear suspension arms.
Adjusting rear belt tension with eccentric hubs.
Assembling and mounting upper camber links.
Further assembly of rear suspension parts.
Installing rear inserts for roll center adjustment.
Assembly of the rear wheel uprights.
Connecting rear suspension links.
Setting rear track-width, camber, and toe.
Final assembly of rear suspension elements.
Mounting the rear anti-roll bar.
Finalizing rear suspension assembly.
Mounting steering and throttle servos to the radio plate.
Securing the receiver to the mounting plate.
Orientation and mounting of servo blocks.
Installation of the fuel cap fitting.
Attaching the assembled radio plate to the chassis.
Assembling the steering linkage system.
Mounting the servo saver and connecting the steering linkage.
Setting the front toe angle of the suspension.
Assembling and installing the steering rods.
Adjusting the gearbox shift point and shoe gap.
Installing the first gear into the gearbox.
Installing the second gear into the gearbox.
Fine-tuning the shoe gap for the 2-speed gearbox.
Mounting the front shock towers to the chassis.
Setting the position and preload for front shocks.
Assembling the front shock absorbers.
Attaching the rear shock mounting components.
Setting the position and preload for rear shocks.
Preparing the engine and clutch components for installation.
Initial assembly of clutch parts.
Adjusting the initial tension of the clutch springs.
Installing the 1st and 2nd gears onto the clutch assembly.
Proper installation of thrust bearing plates.
Critical procedure for setting the clutch gap to 0.7mm.
Procedure for minimizing clutch end play.
Mounting the engine and ensuring proper gear mesh.
Final assembly of various chassis components.
Adjusting the tension of the side drive belt.
Assembling carburetor and brake linkages.
Installing fuel and pressure lines, checking for blockages.
Mounting front and rear tires onto the wheels.
Securing the receiver battery pack to the tray.
To Next Page
