Serta Motion Essentials II - Final Setup and Testing Procedures

Serta
®
Motion Essentials™ II Owners Manual 99301408
8
STEP 6
Plug electrical power cord into a working, grounded electrical outlet.
Note: An electrical surge protection device is recommended (not included).
STEP 7
Briefly activate all functions of the base with the remote control to verify
all features are in working order. If base does not operate, refer to the
Troubleshooting section of this manual.
INSTALLATION
Typical Serta
®
Motion Essentials™ II adjustable base installation is now
complete.
STEP 10
Install mattress on adjustable base.
STEP 8
Return base to the level position.
STEP 9
Install mattress retainer at the foot end of the base as follows:
a. Locate grommeted holes at foot of base (FIGURE 2).
b. Place mattress retainer ends into grommeted holes in top surface
of adjustable base (FIGURE 2). Press down until horizontal retainer
section is flush against base.
MATTRESS
RETAINER
FIGURE 2
FOOT END OF BASE