Server CSP - Unit Take-Down Procedure; Power Off and Disconnection; Removal of Pump and Vessel; Filter Maintenance and Replacement

To Next Page

To Previous Page

CHANGING OR CLEANING

FILTER

FOR BEST UNIT COOLING AND PERFORMANCE,

CHANGE OR CLEAN FILTER AT A MINIMUM OF ONCE

PER MONTH.

1 SEE UNIT TAKE DOWN.

2 ENSURE UNIT IS “OFF” AND UNPLUGGED.

3 TURN UNIT OVER TO ACCESS FILTER HOLDER

AND FILTER ON UNDERSIDE OF UNIT.

4 LIFT OFF FILTER HOLDER BY PULLING IT OFF

FROM ONE EDGE.

5 REMOVE FILTER AND CLEAN OR REPLACE.

• Server Products Inc. Pack of 5 Replacement lters:

86067

• Filter can be cleaned with hot water and

dishwashing detergent. Fully rinse.

6 IF NECESSARY, WIPE DOWN FAN COVER AND

SURROUNDING AREA ON UNDERSIDE OF UNIT

WITH CLOTH DAMPENED WITH DISHWASHING

LIQUID OR MILD SANITIZING DETERGENT.

C EWarning- Electrical shock could occur:

• Be sure to wring out any excess water from

cloth before wiping near fan of unit.

• Dripping water into unit can cause electrical

damage to unit.

7 PLACE NEW OR CLEANED FILTER OVER FAN COVER.

8 REPLACE FILTER HOLDER.

UNIT TAKE-DOWN

1 PRESS SWITCH TO “OFF” POSITION.

2 UNPLUG CORD.

3 REMOVE PUMP.

4 REMOVE PRODUCT VESSEL.

SEE SEPARATE PUMP MANUAL FOR PUMP

INSTRUCTIONS.

UNIT TAKE-DOWN

CHANGING OR CLEANING FILTER

3 4

5 6 7