If the filter is blocked and the appliance is unable to drain, you will need to remove the water from the
appliance at this stage. To do this:
1 Unhook the drain hose from the standpipe or sink.
2 Hold the end of the hose over the bowl on the floor. The water should drain by gravity into the bowl.
3 When the bowl is full, hook the hose back up and empty. Repeat the procedure until the water stops flowing.
4 Clean the filter in the normal way.
NOTE: Never remove the filter during a wash cycle, always wait until the appliance has finished its cycle and
is empty. When replacing the filter ensure that it is securely retightened. This will prevent leaks and stop
young children from being able to undo the filter.
W A S H I N G M A C H I N E
16
To Next Page
Loading...
