EasyManuals Logo

Setra Systems Quick Count User Manual

Default Icon
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
22
Setra Super Count
TM
Operator's Manual
ACCUMULATING COUNT BY ID
To accumulate the count by ID number, perform the following steps.
1. Press the reset key. This will zero the scale and clear the ID, APW and tare registers.
2. Enter the ID, up to ten characters.
3. Press the id key. The scale will automatically load the accumulated count value into the count
accumulator. (If entering a new ID, a value of 0 will be loaded.)
4. Create a valid APW, either by entering the value through the keypad, a bar code scanner, or by
performing the sampling procedure.
5. Place the pieces to be counted on the scale.
6. Press the accum key. The scale will update the count accumulator, copy the new value into the
id-accumulator memory and then display the accumulated count.
7. Press clear to return to the count. Press print if you wish to print the new accumulated value.
(See print setup below.)
ACCUMULATING WEIGHT BY ID
To accumulate the weight by ID number, perform the following steps.
1. Press the reset key. This will zero the scale and clear the ID, APW and tare registers.
2. Enter the ID, up to ten characters.
3. Press the id key. The scale will automatically load the accumulated weight value into the weight
accumulator. (If entering a new ID, a value of 0 will be loaded.)
4. Place the material to be weighed on the scale.
5. Press the accum key. The scale will update the weight accumulator, copy the new value into
the id-accumulator memory, and then display the accumulated weight.
6. Press clear to return to the weight. Press print if you wish to print the new accumulated value.
(See print setup below.)
PRINTING THE ACCUMULATED COUNT OR WEIGHT
To print the accumulated value, follow the steps below.
1. Enter the ID, up to ten characters.
2. Press the id key. The accumulated value for the ID will be copied from memory into the accu-
mulator register.
3. Press the print key.
NOTE: The scale must be setup to print the desired accumulator register (see ScriptCoder or Ap-
pendix II). Accumulating by ID does not store the number of entries in the accumulator.

Other manuals for Setra Systems Quick Count

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Setra Systems Quick Count and is the answer not in the manual?

Setra Systems Quick Count Specifications

General IconGeneral
BrandSetra Systems
ModelQuick Count
CategoryScales
LanguageEnglish

Related product manuals