EasyManuals Logo

Setra Systems Quick Count User Manual

Default Icon
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
40
Setra Super Count
TM
Operator's Manual
CONTINUOUS PRINT MODE
The Super Count’s continuous print feature allows you to program the scale to print at specified time
intervals. For example, to print every five seconds you would enter 5 and press the print key. Since
the key sequence is the same for initiating a script to print, the factory default for this setup is dis-
abled.
To change the continuous print mode follow the steps below:
1. Enter —22220 and press the setup/cal key. The scale will display “IntPrt”.
2.
To Enable the Continuous Print Mode
Press the setup/cal key. The scale will return to the normal weighing mode.
To Disable the Continuous Print Mode
Press the clear key. The scale will display “no Int”. Press the setup/cal key to disable the
continuous print mode. The scale will return to the normal weighing mode.
To Exit This Procedure
Press the clear key to exit from this procedure without changing the status of the continuous
print mode.
If the continuous print mode is enabled, the number that corresponds to the selected time interval
cannot be used as a script’s identifying number. For example, if you wanted to print every 7 seconds,
the number 7 could not be used as an identifying number to store a script.

Other manuals for Setra Systems Quick Count

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Setra Systems Quick Count and is the answer not in the manual?

Setra Systems Quick Count Specifications

General IconGeneral
BrandSetra Systems
ModelQuick Count
CategoryScales
LanguageEnglish

Related product manuals