Why is my Seuic AUTOID Handhelds AUTOID® wearable ring not connecting via Bluetooth?
If your Seuic Handhelds AUTOID® wearable ring isn't connecting to your mobile computer via Bluetooth, first ensure that Bluetooth is enabled on the mobile computer and then try to detect and pair with the AUTOID® wearable ring. Also, make sure the AUTOID® wearable ring is close enough to the mobile computer to be detected via Bluetooth.
What to do if the scanner of my Seuic AUTOID AUTOID® wearable ring stops emitting a laser beam?
If the scanner on your Seuic Handhelds AUTOID® wearable ring stops emitting a laser beam when you press the Scan button, it could be due to several reasons: * The device may have entered sleep mode. To resolve this, press and hold the Power button for 3 seconds to wake it up. * The battery might be too low, causing the device to shut off. Try charging the device. * The system may have crashed. In this case, press and hold the Power button to reboot the device.
How to fix Seuic Handhelds AUTOID® wearable ring when it does not decode with reading bar code?
If your Seuic Handhelds AUTOID® wearable ring isn't decoding when reading a barcode, ensure that the barcode is not damaged or unreadable. Also, verify that the distance between the exit window and the barcode is correct by placing the AUTOID® wearable ring within the appropriate scanning range.
Warning regarding laser radiation and instructions not to stare into the beam.
Essential safety instructions for device operation, charging, cleaning, and handling.
Guidelines for product care, environmental conditions, and data backup.
Details the function and operation of the device's power and scan buttons.
Instructions for initial device setup, including powering on and connection modes.
Steps to power on the device, enter standby mode, and initiate scanning.
Procedure for correctly shutting down the device from standby or sleep modes.
How to put the device into sleep mode and wake it up.
Information on battery charging duration and LED indicators.
Recommended temperature range for optimal battery charging.
Guidance on battery drain and power saving via sleep mode.
Important considerations for battery charging, discharge, and low power states.
Explanation of LED color codes for battery status and charging.
Recommended way to wear the ring device for optimal scanning performance.
Steps and methods for pairing the device via Bluetooth.
Configuration options for scan success, vibration, buzzer, and auto scan.
How the device performs scanning when connected to a terminal.
How scan data is saved locally when the device is offline.
Method to transfer stored scan data to a computer via USB.
General| Category | Handhelds |
|---|---|
| Operating System | Android |
| Scanner | 1D/2D Barcode Scanner |
| RAM | 2GB/4GB |
| Storage | 16GB/32GB |
| Display | 5-inch/5.5-inch |
| Battery | 4000mAh/5000mAh |
| Connectivity | Wi-Fi, Bluetooth, 4G |
| Durability | IP65/IP67 |
To Next Page
