Torrance, CA 90501 USA
www.sevilleclassics.com
Assembly
Step 1. Assemble Base
Tool required: 12 mm wrench (M)
Screw the stem of the casters (F) into the
base by hand. Install the locking casters (E)
on the open end of the base (A). Tighten
until snug with 12 mm wrench (M)
Step 2. Install Neck Frame
Tools required: Allen key (O), 11 mm
wrench (N)
Mount the neck frame (C) to the base
assembly. Secure the screws (J) with the
Allen wrench (O) and tighten the nuts (H)
with the open-end 11 mm wrench (N).
IMPORTANT: Make sure the neck frame is
angled toward the OPENING of the base
Step 3. Assemble Top
Tool required: Allen key (O)
Firmly press the T-bar caps (G) into either
end of the T-bar (B). Install screws (J) with
washers (K) through the T-bar into the table
top using the Allen key (O)
IMPORTANT: Make sure the T-bar is angled
AWAY from the curve
To Next Page
Loading...
