SEW-Eurodrive EI7.B - User Manual

*21362599_0215*
Drive Technology \ Drive Automation \ System Integration \ Services
Service Kit
EI7. Encoder
Edition 02/2015 21362599/EN

Summary

Procedure Overview

Convert Encoder Generation A to B

3.1.1 Remove E17.A Encoder (No Brake)

Step-by-step guide for removing the E17.A encoder from motors without a brake.

3.1.2 Install E17.B Encoder (No Brake)

Procedure for installing the new E17.B encoder on motors without a brake.

3.1.3 Wire E17.B to Box (No Brake)

Instructions for wiring the E17.B encoder to the connection box when no brake is present.

3.1.4 Wire E17.B to Unit (No Brake)

Guide for wiring the E17.B encoder to the connection unit for motors without a brake.

3.2.1 Remove E17.A Encoder (With Brake)

Step-by-step guide for removing the E17.A encoder from motors with a brake.

3.2.2 Install E17.B Encoder (With Brake)

Procedure for installing the new E17.B encoder on motors with a brake.

3.2.3 Wire E17.B to Box (With Brake)

3.2.4 Wire E17.B to Unit (With Brake)

Replace E17.B Encoder

4.1.1 Remove E17.B Encoder (No Brake)

4.1.2 Install E17.B Encoder (No Brake)

4.1.3 Wire E17.B to Box (No Brake)

4.1.4 Wire E17.B to Unit (No Brake)

4.2.1 Remove E17.B Encoder (With Brake)

4.2.2 Install E17.B Encoder (With Brake)

4.2.3 Wire E17.B to Box (With Brake)

4.2.4 Wire E17.B to Unit (With Brake)

SEW-Eurodrive EI7.B Specifications

General

Model	EI7.B
Interface	Ethernet
Operating Voltage	24 V DC
Protection Class	IP20
Transmission Rate	100 Mbps