SEW-Eurodrive MOVITRAC LTP-B User Manual (English)

Other manuals for SEW-Eurodrive MOVITRAC LTP-B

Operating Instructions232 pages

Compact Operating Instructions48 pages

Questions and Answers:

K
Kimberly CruzAug 3, 2025
What to do if SEW-Eurodrive DC Drives will not enable and displays "StoP"?
- M
  Meghan MartinAug 3, 2025
  If your SEW-Eurodrive DC drive won't enable and the display shows "StoP", verify that the hardware enable signal is applied to digital input 1. Also, check that the user +10 V output voltage (between terminals 5 and 7) is correct and the wiring to the user terminal strip. Check P1-12 for terminal / keypad mode; if keypad mode is selected, press the key. Finally, ensure that the supply voltage is within specification.
K
Kyle CannonAug 8, 2025
What to do if SEW-Eurodrive DC Drives show overload or over-current and the motor does not spin?
- D
  David KingAug 9, 2025
  If your SEW-Eurodrive DC drive shows an overload or over-current error and the motor doesn't spin, check whether the rotor is locked. Also, verify that the mechanical brake is released, if the drive is fitted with one.
W
William MartinAug 15, 2025
Why SEW-Eurodrive MOVITRAC LTP-B DC Drives overload or over-current trip on unloaded motor during acceleration?
- L
  Laura LiAug 15, 2025
  If your SEW-Eurodrive DC drive experiences an overload or over-current trip on an unloaded motor during acceleration, check the Star / Delta terminal connection in the motor. Ensure that the rated operating voltage of the drive and motor match. Remember that the Delta connection always gives the lower voltage rating of a dual voltage motor.
R
Robert RosalesAug 21, 2025
How to access extended menus on SEW-Eurodrive MOVITRAC LTP-B?
- A
  Audrey DouglasAug 21, 2025
  To access the extended menus on your SEW-Eurodrive DC drive, ensure that P1-14 is set to the extended access code. This code is "101" unless the code in P2-40 has been changed by the user.
M
Michael MooreAug 27, 2025
Why SEW-Eurodrive DC Drives will not power up in cold ambient temperatures?
- L
  Lee HoltAug 27, 2025
  If the ambient temperature is less than –10 °C, your SEW-Eurodrive DC drive may not power up. Ensure that a local heating source keeps the ambient temperature above –10 °C in these conditions.

SEW-Eurodrive MOVITRAC LTP-B Specifications

General

Protection class	IP20
Enclosure Rating	IP20
Output Voltage	200 V to 240 V
Output Current	2.5 A to 32 A
Protection Features	Overcurrent, overvoltage, undervoltage, overtemperature
Communication interfaces	CANopen
Ambient Temperature	-10°C to +40°C