English
When plugging a high consumption electrical device (greater than 2000W),
keep the ECO mode deactivated (OFF Position).
For use with 12V direct current outlet, always keep the ECO mode deactivated
(OFF Position).
You can use the 12V direct current outlet and the 230V current at the Sam time,
but keep the ECO mode deactivated (OFF Position) at all times.
It is normal that upon deactivating the ECO mode (OFF Position) the engine
increases its noise level as the engine's revolutions increase.
4. Checks prior to operation:
4.1 Battery wiring.
The battery is delivered unplugged from the factory. Before plugging the battery,
check that the ignition switch in the (ENGINE-MOTOR) control panel is in the
"OFF" position. Open the cover by loosening the fastening screws and connect
the battery terminals.
NOTE: Respect the polarity, connect the red cable (+) to the red terminal
(+) of the battery and the black cable (-) to the negative (-) of the battery.
To Next Page
Loading...