SGL Flexy - Dose Self-Learning

27
EN
The setting sequence is the following:
1st Pressure 2nd Pressure 3rd Pressure
+3 Standard -3
Red LED on Blue and Red LEDs on Blue LED on
To exit the temperature setting mode, switch the machine off
then on again.
DOSE SELF-LEARNING
To enter the dose self-learning mode, switch the machine on
and wait until it reaches the heating temperature, and then:
• Turn OFF the machine
• Turn ON the machine while pressing the button of the
short coffee ➌ coffee. After few seconds the blue LED
starts blinking, at this point release the button.
• Press the button of the short coffee ➌ until you have the
desired quantity, at that point release the button.
• If needed, repeat point 3. for the long coffee ❹;
• Turn OFF the machine. When you will turn ON it again the
right quantities will be dispensed.
18
MANUAL
version
19
MANUAL
version
20