Why does the pump on my SGS EC1000 feel unsteady under load?
If the pump on your SGS Construction Equipment feels unsteady under load, the cup seal may be worn out. Replacing the cup seal should resolve this issue.
How to fix SGS EC1000 Construction Equipment pump that will not lift to its full height?
If your SGS Construction Equipment pump won't lift to its full height and feels unsteady under load, this could be due to the reservoir being overfilled or a low hydraulic oil level. Check the oil level by removing the filler plug and top up the oil to the correct level as needed.
Why my SGS Construction Equipment will not hold load?
If your SGS Construction Equipment will not hold a load, it could be due to dirt on the valve seats. To address this: 1. Lower the lifting boom, close the release valve, and remove the oil filler plug. 2. Place one foot on the leg and pull up the lifting boom to its full height by hand. 3. Open the release valve to lower the lifting boom. If the problem persists, replace any worn seals.
What to do if my SGS EC1000 Construction Equipment will not lower completely?
If your SGS Construction Equipment will not lower completely, it could be due to an air block or the unit requiring lubrication. Release air from the hydraulic pump by removing the filler plug and oil external moving parts.
General| Brand | SGS |
|---|---|
| Model | EC1000 |
| Category | Construction Equipment |
| Language | English |
To Next Page
